foreign
In the 1930s, it was discovered that adding sulfite pulp waste liquid to concrete could improve the workability of the mixture, and its strength and durability could also be improved. In 1935, E. W. Scripture of the United States first developed a water-reducing agent with lignin sulfonate as the main component. It was patented in 1937. In the 1950s, it was widely used in slip form concrete, dam concrete and winter construction concrete in the United States. . In 1962, Hattori Kenichi and others from Kaohsiine Co., Ltd. in Japan first developed a water-reducing agent with R-naphthalene sulfonic acid formaldehyde condensate sodium salt as the main component, referred to as naphthalene-based water-reducing agent. This type of water-reducing agent has the characteristics of high water-reducing rate and is suitable for preparing concrete with high strength (compressive strength up to 100MPa) or slump up to 20〔2 or more. Subsequently, in 1964, the Federal Republic of Germany successfully researched the sulfonated melamine formaldehyde resin water-reducing agent. This type of water-reducing agent has the same characteristics as the naphthalene-based water-reducing agent, such as high water-reducing rate, good early strength effect, and low air entrainment. At the same time, it is good for steam-cured concrete. Cement products with high content of products and aluminate (mainly C3A) have better adaptability and can prepare high-strength or high-fluidity concrete. Germany invented fluid concrete, which allowed concrete to be developed from manual pouring or hanging tank pouring to pumping construction, saving manpower, improving work efficiency, ensuring quality, eliminating noise, and greatly improving the level of concrete technology and construction. leap.
Due to the important contribution of high-efficiency water reducing agent to concrete modification, its application has become the third major breakthrough in the history of concrete development after reinforced concrete and prestressed concrete. Marked by the development and application of high-efficiency water reducing agents, concrete technology has entered the third generation from plasticity, dry hardness to fluidization.
In the early 1990s, the United States first proposed the concept of high-performance concrete (HPC), which requires concrete to have high strength, high fluidity, high durability and other properties. High-performance concrete puts forward higher requirements for water-reducing agents and requires high performance. Water reducing agent has the characteristics of high water reducing rate, large fluidity and small slump loss over time. Some new high-efficiency water-reducing agents have been rapidly developed and applied, such as polycarboxylic acid-based and sulfamic acid-based high-efficiency water-reducing agents.
domestic
The start of admixtures in my country is later than that of foreign countries, but it has developed rapidly. In the 1950s, the research and application of lignosulfonates and air-entraining agents began; after the 1970s, naphthalene series high-efficiency water-reducing agents and allium-series high-efficiency water-reducing agents Agents and other products have independently developed products; in the late 1990s, modified melamine, sulfamate, and aliphatic high-efficiency water-reducing agents developed rapidly; since 2006, driven by the construction of high-speed railways, polycarboxylic acid-based high-performance Water reducing agents have also developed rapidly. Water-reducing agents have promoted the development of new concrete technologies in my country and promoted the application of industrial by-products in cementitious material systems. They have gradually become an indispensable material for high-quality concrete.
The development history of water reducing agents at home and abroad
May 03, 2024
Leave a message
