Polycarboxylic acid-based high-performance water-reducing agent
1. The dosage is 0.5%~2.0% of the total weight of the cementitious material, and the commonly used dosage is 0.2%~0.5%; a concrete trial mix test should be carried out before use to find the optimal dosage;
2. It cannot be used in combination with naphthalene series high-efficiency water-reducing admixtures. When used in combination with other admixtures, concrete compatibility tests should also be conducted in advance;
3. Slump is highly sensitive to water consumption, and water consumption must be strictly controlled during use;
4. Pay attention to concrete surface maintenance.
Naphthalene series high-efficiency water reducing agent
1. Dosage range: powder: 0.75-1.5%; liquid: 1.5-2.5%.
2. When using porous aggregate, it is advisable to add water and stir first, then add water-reducing agent.
3. When the slump is large, attention should be paid to the vibrating time not to be too long to prevent bleeding and delamination.
HSB aliphatic superplasticizer
1. Find the optimal dosage through experiments. The recommended dosage is 1.5-2%;
2. Add HSB and mixing water to the concrete at the same time, or you can add it later. When adding HSB concrete, stir for 30 seconds;
3. Due to the large water reduction rate of HSB, before the initial setting of the concrete, a layer of yellow slurry will secrete on the surface, which is a normal phenomenon. The color will disappear after the concrete is pounded and grouted, or the color will disappear naturally after the concrete is strengthened. The color will disappear faster through watering and curing without affecting the internal and surface properties of the concrete.
Instructions for use of water reducing agent
May 09, 2024
Leave a message
